Bosch Dishwasher Repair in Nation Towers

Likely cause: a blocked filter, a clogged or kinked drain hose, a blocked drain pump, or a loose pump cover — the most common Bosch dishwasher fault.

Our fix: we clean the filter and pump, clear the hose and replace the drain pump if needed so your Bosch dishwasher drains fully and clears the E24/E25 code.

Likely cause: water collecting in the base tray triggers the E15 Aquastop float — usually from a leak at the tub, hose, pump seal or spray arm.

Our fix: we dry the base, trace and repair the leak, replace the faulty seal or hose and reset the Aquastop so the machine runs safely again.

Likely cause: blocked spray-arm jets, a clogged filter, a faulty circulation pump, low water temperature, or hard-water scale.

Our fix: we clear the spray arms and filter, test the circulation pump and heating, and descale as needed so dishes come out spotless.

Likely cause: a failed heating element, empty or faulty rinse-aid dispenser, or a heater-circuit fault shown as E09.

Our fix: we test and replace the heating element or dispenser and confirm the rinse and dry cycle works so dishes come out dry.

Likely cause: a closed or low-pressure tap, a blocked inlet filter, a faulty water-inlet valve, a triggered Aquastop hose, or a flow-meter fault (E18).

Our fix: we clean the inlet filter, check the tap and Aquastop hose, and replace the inlet valve so the machine fills correctly.

Likely cause: a failed flow-through heating element, a faulty thermostat or NTC sensor, or a control-board fault.

Our fix: we test the element and sensor and fit a genuine Bosch replacement so your wash reaches the correct temperature.

Likely cause: a worn door latch, a broken hinge or tensioning cable, or a misaligned integrated door panel.

Our fix: we replace the latch, hinge or door-spring cable and realign the door so it closes and starts reliably.

Likely cause: a stuck or broken dispenser flap, a weak spring, or a wax-motor / control fault.

Our fix: we replace the dispenser unit or wax motor so detergent releases at the right point in the cycle.

Likely cause: a power-supply issue, a faulty door switch, an on/off switch fault, or a control-board problem.

Our fix: we check the power, door switch and controls and repair or replace the control board so your Bosch dishwasher starts and completes every cycle.